Journal of Industrial Engineering and Robotics
ISSN 3061-4112, ISSN-L 3061-4112
 

RESEARCH ON THE CONTROL OF PARTS WITH A CONICAL PROFILE IN PARTS IN THE AUTO INDUSTRY

Published in Journal of Industrial Engineering and Robotics, Volume 7, Number 3
Written by STAICU Constantin-Georgian, S.I. dr.ing. TEODORESCU-DRĂGHICESCU Florin
Scientific coordinators:

The subject of this research paper is the control of conical profile parts. In the beginning it presents the importance of the control of conical profile parts and why they should be very precisely controlled. Then the actual state presents the usage of calibers. After that it shows how the new technologies work, first the inductive probes and second the method using air gages. At the end of that are presented the advantages and disadvantages of all the methods showed before, and the new technologies are both cheaper and more precisely than the old ones. In the end it’s written about the way that conical profile parts are tolerated. Finally the conclusions are about how the new technologies are more efficient then the old ones and how they should be used more often because of the fact that the conical profile parts are used in the most important parts of the car.

[Read full article] [Citation]

2023, RESEARCH ON THE CONTROL OF PARTS WITH A CONICAL PROFILE IN PARTS IN THE AUTO INDUSTRY. Journal of Industrial Engineering and Robotics, Volume 7, Number 3, ISSN 2601-5471, 24-29.

The publisher is not responsible for the opinions published in the Volume. They represent the authors’ point of view.

© 2024 Journal of Industrial Engineering and Robotics. All Rights Reserved. To be cited: Journal of Industrial Engineering and Robotics.

Powered by INTELIDEV